Rokonet ORBiT-14 Bedienungsanleitung PDF herunterladen (Seite 50)

Installation and Programming Manual

ZONES: ZONE PARTITIONS

ZONES: ZONE TYPE

Quick Key Item Default Explanation

2 2

PARTITIONS

all zones

are

assigned

Partition 1

§ programs the Partition Assignment(s) for each zone

from this display, press [ENTER]

specify its two-digit Zone Number

press [ENTER] again

§ the “xx” in the Z=xx designation refers the number of

the zone currently being given a partition(s) assignment

§ when programming a zone’s partition assignment(s),

keep in mind that in a multi-partitoned system, a zone

may be assigned to more than one partition

§ a system “without” partitions is regarded as having a

single partition (i.e. Partition 1)

§ use the [STAY] key to toggle between YES (Y) or

NO (,), as to whether the currently-programmed zone

is assigned to the designated partition or use keys 1 to

8 to toggle partition status to YES (Y) or NO (,)

§ use either the [STAT] or [BYP] keys to move the

cursor left or right, respectively

2 3

Zone

Type

ZONE TYPE

---

§ programs the Zone Type for each zone; there are

20 Zones Types, each defined below

§ to program the Zone Type for any zone:

from this display, press [ENTER]

specify its two-digit Zone Number

press [ENTER] again, and select among the following:

00 Not Used --- § used to disable a zone

§ all unused zones should be given this designation

01 Exit/Entry 1

default for

Zone 1

§ used for entry/exit doors

§ if violated, zones given this designation will not cause

an intrusion alarm during the Entry and Exit Delay

periods specified under Exit/Entry 1 in the Time Define

section

02 Exit/Entry 2 ---

§ as above, except that Exit/Entry 2 time intervals apply

2 3 zz

03 Exit(OP)/Entry § used for an entry/exit door that, for convenience, may

be kept open during the disarmed period

§ such a zone behaves as described in Entry/Exit 1,

above, except that, if faulted at the time the system is

armed, it will be bypassed and NOT prevent system

arming

§ to avoid an intrusion alarm, however, it must be

secured before the expiration of the Exit Delay period

04 Entry Follower default for

Zone 2

§ usually assigned to motion detectors and to interior

doors protecting the area between the entry door and

the keypad

§ a zone(s) given this designation will cause an

immediate intrusion alarm when violated unless an

Entry/Exit zone was violated first

§ if so, an Entry Follower zone(s) will remain bypassed

until the end of the Entry Delay period

INSTALLER PROG:

2)ZONES ↓↓

SUBJECT: ZONES

2)PARTITIONS ××

P=12345678 Z=xx

Y.......

SUBJECT: ZONES

3)ZONE TYPE ××

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

Rokonet ORBiT-14 Bedienungsanleitung Seite 50

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Rokonet ORBiT-14