
Installation and Programming Manual
26
Section 3: Programming Your ORBIT-Pro
S
S
u
u
m
m
m
m
a
a
r
r
y
y
o
o
f
f
I
I
n
n
s
s
t
t
a
a
l
l
l
l
e
e
r
r
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
M
M
e
e
t
t
h
h
o
o
d
d
s
s
As a source of general reference, the following table lists the options available when programming an ORBIT-Pro
installation. Except for this reference, this section will concern itself only with such programming from an LCD
Keypad only.
PROGRAMMING METHODS
LOCALLY (at the panel) REQUIREMENTS
• from any LCD Keypad (covered in this manual)
• the keypad must be DIP switch programmed
and wired to the ORBIT-Pro
• power must be applied to the ORBIT-Pro
• from a portable computer
• see the Upload/Download Programming Manual
(p/n 5IN296UD) for additional information
• the PC must be IBM
®
-compatible
• Rokonet's Upload/Download Software (p/n
RP296UD) must be installed
• the Bus Adapter (p/n RP296BA) cable and
plug must be connected between a serial
(COM) port on the PC and the ORBIT-Pro’s
“J1” connector–or the equivalent connection
* on the 4-wire BUS
• via the Program Transfer Module (p/n RP296EE), a
tiny circuit board into which a copy of a panel’s
programmed configuration is stored–from which it
may later be transferred to any installation when
temporarily plugged into its 4-wire bus
• see page 112 for detailed instructions) on the use of
the Program Transfer Module
• the Program Transfer Module (p/n RP296EE)
*
REMOTELY (at the alarm company) REQUIREMENTS
• from a personal computer
• see the Upload/Download Programming Manual
(p/n 5IN296UD) for additional information)
• the PC must be IBM
®
-compatible
• Rokonet's Upload/Download Software (p/n
RP296UD) must be installed an applicable
modem must be installed and configured
access to a telephone line
*
Table 3-1
* Not for UL Installations
Kommentare zu diesen Handbüchern