Rokonet ORBiT-14 Bedienungsanleitung PDF herunterladen (Seite 13)

Installation and Programming Manual

Wiring to External Sounders

External Sounders

BELL/S

+ –

Jumper J3

§ connect suitable wire to the external sounding device(s), whether a bell, an

electronic siren, or a loudspeaker

§ consider a larger wire gauge (e.g. 18-16) if the distance separating the

sounder(s) and the panel is significant; consider also the sounder’(s)s

current draw when choosing a suitable wire gauge

§ polarity must be observed for electronic siren(s) and/or polarized bells (if

used)

§ if an external sounder connection is not made, use a 2200Ω resistor in its

place to avoid potential sounder supervision problems

§ be sure to appropriately position the board's BELL/LS Jumper (J3), as

follows:

- if your external sounder is a Loudspeaker (without a built-in sound

driver), position jumper J3 so it covers both pins; doing so causes the

panel, if so programmed, to produce a continuous oscillating voltage

for burglary/panic alarms, and an interrupted oscillating voltage for fire

alarms

- if your external sounder is either a Bell or an Electronic Siren (equipped

with a built-in sound driver), position jumper J3 so it does NOT cover both

pins; as such, a steady 12 Volts DC is produced at the sounder terminals

during burglary/panic alarms; a slow, pulsing voltage is produced during a

fire alarm

Wiring to an

External, Triggerable

Device

Utility Output 1

AUX U01

+ –

§ wire these terminals to any device [e.g. the coil of a 12 VDC, 70 mA (max)

relay] which you want activated when Utility Output 1 is triggered (for

additional information, see the Utility Outputs section on page 63)

Telephone Line

Connections

(typically derived from an

installed RJ31X jack)

§ to the Main Board’s LINE terminals, connect the two wires (usually red and

green) from the RJ31X jack’s Direct Connect Cord, corresponding to the

incoming telephone line

§ to the Main Board’s SET terminals, connect the two wires (usually gray

and brown) from the RJ31X jack’s Direct Connect Cord, corresponding to

the premises’ phones

DEFAULT Jumper

§ be sure the J2 Jumper is NOT placed over the two corresponding pins

§ place this jumper over a single pin to prevent its loss

GROUND

§ refer to the grounding suggestions, previously discussed on page 11

Flying Leads

RED and BLACK

§ have the Standby Battery handy (typically 12 VDC, 6 AH, typical)

but do NOT connect it at this time

§ wire the output from a 16.5 VAC, 40 VA transformer to the Main Board’s

AC terminals

§ use the appropriate wire gauge (e.g. 18-16)

§ do NOT plug in the transformer at this time

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

Rokonet ORBiT-14 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Rokonet ORBiT-14