Rokonet ORBiT-14 Bedienungsanleitung PDF herunterladen (Seite 49)

Installation and Programming Manual

§ IMPORTANT:

§ in One-By-One, the listing of each zone’s parameters are

sequential; thus, once Zone 1’s parameters have been

programmed, they will be followed by Zone 2’s, then Zone 3’s, and

so forth

§ if you choose to program one or more of the system’s zones using

the One-By-One method, changes you make to any (or all) of the

Zone Parameters will NOT be recorded unless you go through the

entire One-by-One list–which ends with the Zone Label parameter

of the last zone you wish to program

§ after making any changes to the above-mentioned Zone Label

parameter, press [ENTER]

§ doing so will produce a one-second tone

§ only then can you be assured that change(s) you made to the zone

being programmed will be recorded when you exit the One-by-One

Programming Mode

§ as an alternative to One-By-One programming (in which all of a

zone’s parameters may be programmed at the same time), you

can select a single parameter and program (or review) it for each of

the system’s zones

§ to do so, choose a specific zone parameter among the following six

zone categories:

2) Partitions

3) Zone Type

4) Zone Sound

5) Zone Termination

6) Loop Response

7) Zone Labels

8) Miscellaneous

page 50

page 53

page 54

page 56

page 110

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 69 70

Keine Kommentare

Rokonet ORBiT-14 Bedienungsanleitung Seite 49